电池供电小夜灯电路

电池供电小夜灯电路-电感生产-Battery-powered Night Lamp

1,R2___________1M 1/4W Resistors
R3_____________47K 1/4W Resistor (optional: see Notes)
R4____________Photo resistor (any type, optional: see Notes)

C1____________100nF 63V Polyester Capacitor
C2____________220΅F 25V Electrolytic Capacitor

D1______________LED Red 10mm. Ultra-bright (see Notes)
D2___________1N5819 40V 1A Schottky-barrier Diode (see Notes)

IC1____________7555 or TS555CN CMos Timer IC

B1_____________1.5V Battery (AA or AAA cell etc.)

Device purpose:

This circuit is usable as a Night Lamp when a wall mains socket is not available to plug-in an ever running small neon lamp device. In order to ensure minimum battery consumption, one 1.5V cell is used, and a simple voltage doubler drives a pulsating ultra-bright LED: current drawing is less than 500΅A.
An optional Photo resistor switches-off the circuit in daylight or when room lamps illumina电感器生产te, allowing further current economy.
This device will run for about 3 months continuously on an ordinary AA siz贴片电感ed cell or for around 6 months on an alkaline type cell but, adding the Photo resistor circuitry, running time will be doubled or, very likely, triplicated.

Circuit operation:

IC1 generates a square wave at about 4Hz frequency. C2 & D2 form a voltage doubler, necessary to raise the battery voltage to a p功率电感器eak value able to drive the LED.

Notes:

IC1 must be a CMos type: only these devices can safely operate at 1.5V supply or less.

If you are not needing Photo resistor operation,电感器类型 omit R3 & R4 and connect pin 4 of IC1 to positive supply.

Ordinary LEDs can be used, but light intensity will be poor.

An ordinary 1N4148 type diode can be used instead of the 1N5819 Schottky-barrier type diode, but LED intensity will be reduced due to the higher voltage drop.

Any Schottky-barrier type diode can be used in place of the 1N5819.

大电流电感

微带线如何替代LC？微带线，对于做微博和射频的同仁是最熟悉不过的。这里也就不介绍原理性的知识，毕竟很多专业书籍和教材已经讲解很多。还是我写东西的一贯特点，举例子。用微带线的分布参数代替集

[充电器]光伏充电控制器的mppt控制各位大神，本人刚做光伏充电器不久，设计光伏电池给锂电池mppt电路的过程当中，由于对充电器的能耗要求，控制电路的单片机想用一个最简单的完成，请教大家有哪些管脚少和能耗低的单片机完成mppt控制？？？在此谢谢各位啦！可以看看如韵电子推出的CN3722带MTTP控制，希望能帮到你。 DSC-CN3722.pdf(283.01 KB, 下载次数: 144)2015-1-21 10:37 上传点击文件名下载附件  QQ：525667597  0755-83203064 郑生如果是为单节锂电池充电的话,可以使用如韵

UCOS系统与裸机的中断相比有什么不同的？如题，最近在看ucos,看的一知半解，然后我就有个问题，裸机的时候我们可以用中断来控制任务定时切换，在ucos是采用抢占式的方法，也是提前分配优先级。只有到UCOSIII中才支持时间片轮

注塑加工厂